Arrow Wrap Installation

Step 1:  Remove old fletching

Step 2:  Clean arrow with adhesive removal (Goof, GooGone, etc)

Step 3:  Wipe arrow off with alcohol (rubbing, not whiskey)...

DO NOT wipe the wrap off with anything

Step 4: Lay wrap, adhesive side up on a solid surface (mouse pad works great)

Step 5:  Line up the end of the arrow (nock removed) with the end of the wrap and slide until the arrow meets the wrap (parallel)

Step 6: Press down and roll the arrow slowly and with some pressure into the wrap

Step 7:  Fletch

Fletching Glue Recommendation

We use Bohning Fletch Tite and Bohning Fletch Tite Platinum with both feathers and blazer vanes.  We recommend that you leave each feather/vane on the jig with the clamp in place for 15-20 minutes before moving on to the next.  After fletching your arrow, put a drop of glue at the top and bottom of the fletching.

Do not smoke around your fletching area...it will dry out adhesives. 

Arrow Wrap Removal

Step 1:  Heat the wrap (about an inch at a time) with a hairdryer or over boiling water (steam) for a couple of minutes

Step 2:  Peel off the wrap and fletching

Limb Skin Application

Step 1: clean the bow limbs with soapy water to get rid of all contaminents

Step 2: Mix up some soapy water in a spray bottle with a drop of alcohol (Rubbing)

Step 3: Peal off limb skin from paper backing and spray sticky side of skin with solution

Step 4: Line up limb skin straight down bow limb and squeegee it with applicator included.

Step 5: let it dry for aprox 15min so the water evaporates. (test it by trying to peal skin off the limb) if it peals smooth it out and let dry until it wont peal off.

Step 6: Trim extra vinyl with a BRAND NEW razor blade. This will give you the cleanest cut on the edge of the skin.

Step 7: -OPTIONAL- Spray a protective finish over the top. (Not needed) DO NOT USE TRUE OIL OR ANYTHING OF THAT KIND.

Repeat as necessary.